Carel GDSRSHFC00 - RILEVA TE App Features; Connecting the Device via Bluetooth

17
ENG
Gas Leakage Detector +0300047IE rel 1.1 - 26.04.2023
Operation
3.7 RILEVA TE app features
The “RILEVA TE” app lets users fully exploit the potential of the new Carel GLD Small series gas detectors, allowing sim-
ple and intuitive interaction with the gas detector. This simplies conguration by using a smartphone to interface
with the CAREL GDS* gas leakage detectors.
The RILEVA TE app is available on the ANDROID store, and will soon also be available on the IOS store.
RILEVA TE can be used to perform the following functions:
• Conguration: modify alarm thresholds, congure Modbus settings, modify relay behaviour and manage analogue output
settings
• Maintenance: check correct functioning of the device
• Calibration, complete with calibration report
• Display of current gas concentration measurement and indication of alarm/fault status
3.7.1 Connecting the device via Bluetooth
Before connecting to the device via the RILEVA TE app, rst make sure that the BLUETOOTH connection and GEOLOCATION are
enabled on the smartphone used.
Make sure that Bluetooth mode has been activated on the GLD small using the magnetic latch, as described in the previous
chapter.
It is recommended to wait for the end of the warm-up phase before activating the Bluetooth connection.
The Bluetooth connection should be established during installation or maintenance.
It is not recommended to use the app to monitor the amount of gas measured in the environment.
Activation via magnetic latch is disabled if there are any active alarms/warnings and automatic reset has been set.
If manual reset mode has been selected, Bluetooth can be activated, however the alarms are disabled during connection.
The alarms are in fact disabled when Bluetooth is active.
Open the RILEVA TE app (previously downloaded); the following screen is displayed
Login screen
Select:
• Operator, to continue displaying the gas detector variables and parameters.
• Technician, for password access and the possibility to set the parameters and var-
iables.
The password to unlock the device is 2222.