To Next PageTo Next Page
Need help?Do you have a question about the Carel GDSRSHFC00 and is the answer not in the manual?
General| Product Type | Gas Detector |
|---|---|
| Model | GDSRSHFC00 |
| Detection Gas | Refrigerant gases |
| Measurement Range | 0-1000 ppm |
| Operating Humidity | 0-95% RH (non-condensing) |
| Protection Rating | IP65 |
| Output signal | 4-20 mA |
| Power Supply | 24 VDC |
| Refrigerant compatibility | HFC, HFO |
| Detection Principle | Semiconductor sensor |
Details general information and considerations for installing the gas detector correctly.
Describes the steps for physically mounting the sensor and making electrical connections.
Guides on configuring the device using the internal rotary switch and voltage readings.
Explains how alarms are activated and provides tables for alarm set points.
Details Modbus variables for reading and writing registers, including functions 04, 06, 16, 05, 01.
Outlines the periodic calibration procedure using a calibration kit and gas.
Step-by-step guide for performing calibration using the RILEVA TE mobile application.
Explains the calibration process using Modbus communication and registers.
Details the specific registers and coils used for the calibration process.
Step-by-step guide for replacing the sensor in the built-in version of the detector.
Step-by-step guide for replacing the sensor in the remote version of the detector.
