32
ENG
Gas Leakage Detector +0300047IE rel 1.1 - 26.04.2023
Maintenance
4.5.2 Remote version
Detach the remote sensor from the housing used to perform
the measurement in normal conditions
1. Loosen the screw on the cable gland by unscrewing be-
tween points 1 and 4 in the gure, so that the cable is free
to move inside the cable gland
2. Completely unscrew the screw positioned in point 2 by
unscrewing between points 2 and 4 shown in the gure. In
the event of di culties when loosening, use pliers in point
2
3. Open the container by pulling points 1 and 4 in the gure,
between the points, so as to remove the electronic board
from its housing
Unplug the sensor connector from the electronic board
Unscrew the sensor from the tube so as to separate it from the
other parts of the device
Make sure the new sensor has the same part number as the
one just removed.
Screw in the new sensor, making sure to use the highlighted
part and not the opposite part.
Place the electronic board inside the tube, making sure that
the connector highlighted in point 1 is positioned in the direc-
tion of the sensor.
Plug the connector into the electronic board
Place the board inside the tube
Screw the cable gland to the tube, making sure that the cable
is free to move inside the cable gland.
Tighten the cable gland on the cable, making sure that the re-
taining gasket is inside the cable gland.
To Next Page
Loading...
