To Next PageTo Next Page
Need help?Do you have a question about the Carel GDSBI20C00 and is the answer not in the manual?
General| Protection | IP65 |
|---|---|
| Product Type | Gas Detector |
| Model | GDSBI20C00 |
| Power Supply | 24 Vac/dc |
| Output Signal | 4-20 mA |
| Detection Gas | Refrigerant |
| Detection Principle | Infrared |
| Operating Humidity Range | 0% to 95% RH (non-condensing) |
| Certification | CE |
General warnings for product use, environment, and handling, including ESD precautions.
Step-by-step mounting, wiring, and additional notes for device installation.
Instructions for configuring the device using the rotary switch and the RILEVA TE app.
Explanation of how to set parameters using the rotary switch and voltage conversion table.
Explains alarm activation and provides default alarm setpoints for different gas groups.
Lists alarm setpoints for gas groups and details detected gases.
Overview of RILEVA TE app features for configuration and maintenance.
Procedure for periodic sensor calibration using a calibration kit and its necessity.
Step-by-step guide for performing calibration using the RILEVA TE app.
Steps for performing fresh air calibration using the RILEVA TE application.
Procedure for span gas calibration using the RILEVA TE app, including reference values.
Completing span calibration and entering temperature/humidity for calibration certificate.
Reviewing calibration summary, saving data, and generating a PDF calibration report.
Instructions to perform zero and span calibration via Modbus communication.
Flowchart illustrating the sequence and logic for Modbus calibration registers.
Detailed procedures for replacing the sensor in the device.
Detailed instructions for replacing the sensor in the built-in version of the device.
Detailed instructions for replacing the sensor in the remote version of the device.
