Carel GDSRSHFC00 - Warning Fault Mode

37
ENG
Gas Leakage Detector +0300047IE rel 1.1 - 26.04.2023
Further information
5.4.2 Warning Fault mode
In this operating mode, the behaviour of the relays can be set in the event of a malfunction or no communication between the
pre-calibrated sensor and the main board.
This operating mode can be enabled or disabled from the supervisor by setting the RelayWF variable or from the parameters
section of the app.
Warning Fault mode
enabled
Alarm threshold
Alarm relay
Warning threshold
Warning relay
Fault condition
Warning LED (yellow)
Alarm LED (red)
Normal mode LED (green)
Warning Fault mode
disabled
Alarm threshold
Alarm relay
Warning threshold
Warning relay
Fault condition
Warning LED (yellow)
Alarm LED (red)
Normal mode LED (green)