What does it mean if my Carel GDWBS01A00 unit shows a voltage out of specification 5 V?
If your Carel Gas Detectors unit shows a voltage out of specification for 5 V, it means the terminal voltage is out of range. It is recommended to contact service.
What does it mean if my Carel GDWBS01A00 unit shows a voltage out of specification 5.4 V?
If your Carel Gas Detectors unit shows a voltage out of specification for 5.4 V, it means the terminal voltage is out of range. It is recommended to contact service.
What does it mean if my Carel GDWBS01A00 Gas Detectors unit shows a voltage out of specification 12 V?
If your Carel Gas Detectors unit shows a voltage out of specification for 12 V, it means the terminal voltage is out of range. It is recommended to contact service.
What does it mean if my Carel GDWBS01A00 Gas Detectors unit shows a voltage out of specification VIN?
If your Carel Gas Detectors unit shows a voltage out of specification for VIN, it means the terminal voltage is out of range. It is recommended to contact service.
What does 'Analogue output fault' mean on Carel Gas Detectors (GDWB only)?
An analogue output fault on your Carel Gas Detectors (GDWB only) indicates an error updating the DAC value. Try power cycling the device. If the issue persists, contact service.
What does a Bluetooth fault mean on my Carel GDWBS01A00 Gas Detectors, and how can I fix it?
A Bluetooth fault on your Carel Gas Detectors device indicates that a Bluetooth module error has been detected. Try power cycling the device. If the issue persists, contact service.
What to do if my Carel GDWBS01A00 show a software fault?
If your Carel Gas Detectors unit is showing a software fault, this could be due to a firmware error. Try power cycling the device. If the issue persists after restarting, it is recommended to contact service.
What to do if my Carel GDWBS01A00 Gas Detectors unit is showing a 'Sensitive element fault'?
If your Carel Gas Detectors is showing a 'Sensitive element fault', it means that faults were detected in the sensitive element. You should replace the sensor module.
What should I do if my Carel GDWBS01A00 Gas Detectors unit displays a 'Sensor module ADC write fault'?
If your Carel Gas Detectors unit displays a 'Sensor module ADC write fault', this indicates that it cannot write to the sensor module ADC. You should check the sensor connection and/or replace the sensor module.
What should I do if my Carel GDWBS01A00 unit displays a 'Sensor module ADC read fault'?
If your Carel Gas Detectors unit displays a 'Sensor module ADC read fault', this indicates that it cannot read from the sensor module ADC. You should check the sensor connection and/or replace the sensor module.
General| Type | Gas Detector |
|---|---|
| Model | GDWBS01A00 |
| Power Supply | 24 VDC |
| Protection Rating | IP65 |
| Detection Method | Electrochemical |
| Output Signal | 4-20 mA |
| Detection Principle | Electrochemical |
| Output | 4-20 mA |
| Operating Temperature | -20 to +50 °C |
| Housing Material | ABS Plastic |
To Next Page
