EasyManua.ls Logo

Carel m chiller - Unit Indication Sequences

Carel m chiller
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Manutenzione compressore 1 e 2
Quando il numero di ore di funzionamento di un compres-
sore supera la soglia di manutenzione (di fabbrica pari a
zero, quindi il controllo è disabilitato) viene attivata la
segnalazione di richiesta di manutenzione. Non viene atti-
vato il buzzer ed il relè d'allarme; il LED giallo a bordo
scheda continua a lampeggiare con frequenza di circa 1
secondo. Il valore della temperatura visualizzato a display,
invece, lampeggia (alternativamente al messaggio di
avviso).
5.3 Sequenza delle segnalazioni della macchina
Ponendo in stand by il µchiller con almeno un allarme pre-
sente, tutte le segnalazioni rimangono attive tranne il buz-
zer che si spegne; si ribadisce, inoltre, che a macchina già
in stand by non viene rilevato nessun allarme che non sia
di sistema (ovvero solo gli allarmi sonda ed eeprom ven-
gono gestiti, quelli da ingresso digitale no).
(1) circa 2 volte al secondo
(2) qualora abilitato
Maintenance of 1st/2nd compressor
When the compressor exceeds a selected operating hours
threshold (factory-set value = 0 hour, therefore the control
is disabled) a message prompting maintenance will
appear on the display. Neither the buzzer nor the alarm
relay will activate. The yellow LED will blink at normal fre-
quency as well as the temperature value on display alter-
natively to the maintenance indication.
5.3 Unit indication sequences
The unit displays messages every 32 seconds. When
"µchiller" is in stand-by and there is at least one active
alarm condition, all the LED indicators will remain active
except the buzzer. When in stand-by, however, "µchiller"
detects probe and eeprom alarms only; alarms from digital
inputs will not be managed.
(1) about twice a second
(2) whenever enabled
43
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
E1
E2
E3
E4
E5
EE
FL
H1
L1
C1
F1
A1
d1
r1
n1
H2
L2
C2
F2
A2
d2
r2
n2
Cn
LO
Lampeggia/Flashes
Acceso/ON (2) Eccitato/Energized
Messaggio
Error mess.
LED giallo sulla scheda base
Yellow LED located on singol compr. board
Display Cicalino
Buzzer
Relè allarme
Alarm Relay
lampeggia velocemente
blinks faster (1)
lampeggia normalmente
blinks at normal frequency
lampeggia velocemente
blinks faster (1)
lampeggia normalmente
blinks at normal frequency
lampeggia velocemente
blinks faster (1)
lampeggia normalmente
blinks at normal frequency
lampeggia velocemente
blinks faster (1)
cn lampeggia/cn flashing
Lampeggia/Flashes
Spento/OFF
Acceso/ON (2)
Spento/OFF
Acceso/ON (2)
Disec./Disenergized
Eccitato/Energized
Disec./Disenergized
Eccitato/Energized

Table of Contents

Related product manuals