Need help?Do you have a question about the Carel UltraCella and is the answer not in the manual?
General| Model | UltraCella |
|---|---|
| Communication Protocols | Modbus RTU |
| Type | Controller |
| Operating Temperature | -10°C to 55°C |
| Storage Temperature | -20°C to 70°C |
| Relative Humidity | 10% to 90% RH (non-condensing) |
| Protection Rating | IP65 |
| Display | LCD |
| Connectivity | RS485 |
| Relay Contact Rating | 250 VAC |
Details available expansion modules like EVD, 3PH Evaporator/Full, and Power modules.
Covers mounting and connection of the Ultra EVD module for electronic expansion valves.
Details mounting and wiring for the Ultra Power module, including 3Hp relay.
Explains installation and connection of the 3PH Evaporator module.
Covers installation and connection for the 3PH Full module.
Covers parameter modification, set point adjustment, and password protection.
Step-by-step guide to modify the set point value on the controller.
Procedure for modifying parameters on single-digit display models.
Procedure for modifying parameters on double-digit display models.
Explains various operational procedures and settings.
Details how to activate defrost cycles based on temperature or time.
Provides access to various functions like HACCP alarms, continuous cycle, and logging.
Guides on uploading/downloading parameters and saved alarms via USB.
Outlines the initial setup steps required for the UltraCella control system.
Lists essential parameters to configure during the commissioning phase.
Specific commissioning procedure for models with single-digit displays.
Specific commissioning procedure for models with double-digit displays.
Guides on performing commissioning using the UltraCella Service Terminal.
Describes the initial startup and guided configuration via the Service Terminal wizard.
Covers essential main function configurations for the control system.
Explains how set-point and differential affect compressor operation.
Details how to configure different types of analogue inputs for probes.
Details the different types of defrost (heater/hot gas, temp/time) that can be managed.
Explains fan operation modes, including fixed and variable speed control.
Covers compressor start/stop delays and minimum run/off times.
Specific steps for commissioning the Ultra EVD module with UltraCella.
Configuration procedure for the Ultra 3PH Evaporator module.
Configuration steps for the Ultra 3PH Full module.
How to turn the controller on and off via keyboard, digital input, or supervisor.
Defines set point and differential and their role in compressor operation modes.
Describes the pump down function to empty the evaporator before compressor stops.
Introduction to defrost parameters and event scheduling.
Covers fixed and variable speed fan management.
Provides detailed technical specifications for the UltraCella unit.
Detailed wiring diagrams for the 3PH Evaporator Module.
Detailed wiring diagrams for the 3PH FULL Module.
To Next Page
