Check for any fluid leakage
While running, apply (502375) grease to cam follower bearings, 8 strokes of a
standard ‘cartridge’ grease gun (502373).
Inspect Linear Bearings, Rod, Cam and Cam followers for excessive wear, replace
if excessive wear can be felt or seen.
Inspect Piston and Replace Piston Seals / Bellows / Springs.
Inspect Linear Guide Bearing and Guide Rails for excessive wear.
Inspect Cam and Cam followers for excessive wear, replace if excessive wear can
be seen.
Replace main shaft bearings. Linear Guide Bearings, Guide Rails and Cams if
excessive wear can be seen.
Inspect Piston & Outlet Ball Checks, replace as necessary.
Grease Main Shaft Bearing with 502375 grease.
Use only 502375 (KP2N-20 DIN 51825) Grease for Cam Follower Bearing.
Check for any excessive mechanical noise
Check for excessive fluid pressure pulsation
77-3311 R1.0 27/36 www.carlisleft.com
To Next Page
Loading...
