To Next PageTo Next Page
Need help?Do you have a question about the Carlisle Binks E2-15 and is the answer not in the manual?
General| Model | E2-15 |
|---|---|
| Category | Water Pump |
| Power Source | Electric |
| Voltage | 115V |
| Material | Cast Iron |
Defines practices leading to severe injury, death, or property damage.
Defines practices leading to minor injury, product or property damage.
Provides important installation, operation, or maintenance information.
Units for Zone 1, ATEX Cat 2; electrical connections per local regs.
Lockable isolator, pressure relief valve, pressure switch setup.
Motor wiring for direction, hazardous area compliance, grounding.
Connecting hoses and ensuring adequate air space for cooling.
Verify correct gearbox oil plug/venting plug.
Ensure connections, interlocks, material, and outlet are ready.
Working life affected by motor, usage, and standards.
Main Piston Seal and Cam Follower are critical.
Daily, weekly, monthly, annual, and 5-year inspection/service tasks.
Verification, seal leaks, and overhaul procedures for the gearbox.
Ex motor maintenance standards and repair procedures.
Diagnosing issues with gearbox, bearings, and carriage.
Diagnosing issues with priming, operation, leaks, and pulsation.
Steps for testing after major overhaul.
Running the pump, checking for leaks and noises.
Applying grease to specific bearings during operation.
Safe procedure for draining fluid from the pump.
Limited warranty coverage, conditions for voiding.
Contact information for assistance and locating distributors.
