18” CHIPPER MACHINE OPERATION
39
NEVER ALLOW ANYONE TO OPERATE
THE WINCH CONTROL VALVE WHILE
AN OPERATOR IS IN THE VICINITY OF
THE WINCH ROPE!!! ROPE BURNS OR
OTHER INJURIES COULD OCCUR IF
THE PERSON BECAME ENTANGLED
OR TRIPPED BY THE ROPE. THE ROPE
COULD BREAK OR COME LOOSE AND
WHIP AROUND AND CAUSE SEVERE
INJURY. USE A LARGE BLANKET,
JACKET, OR TOWEL TO WEIGHT THE
ROPE WHEN REELING IN TO REDUCE
RISKS IF THE ROPE COMES LOOSE OR
BREAKS. For more information on correct
operation of the winch, please read the
winch operator’s manual.
7. Pull the tree to the chipper using the
winch control valve.
8. Pull the tree up into the chipper infeed
chute. Remove the winch rope and
secure in the storage position.
9. Rotate the winch selector switch back to
the FEED WHEEL ON position and
follow the standard operating procedures
for chipping the material.
WINCH CONTROL VALVE
(IF EQUIPPED)
To Next Page
Loading...
