18” CHIPPER MACHINE MAINTENANCE
48
LIGHTS WIRING
• Check lighting wire connections for
damage, and loose or broken wires.
• Make sure the lights are working
properly at all times when towing.
• See the Machine Wiring section of this
manual for wiring diagram.
BREAKAWAY SWITCH
• Check to make sure the breakaway
switch is working properly. This switch
activates the brakes if the chipper ever
becomes uncoupled from the tow
vehicle. When the switch separates,
power is sent to the brakes. Check the
wiring for any loose or broken wires.
Replace or rewire if necessary.
DISCHARGE CHAIN TENSION
• Check tension on discharge chain
weekly. The chain should deflect 1/2"
when adjusted properly.
• To check the tension, remove the chain
guard. Make sure the engine is off
before starting.
• Remove the six bolts in the chain guard
and remove the guard cover. Keep the
bolts and washers together to replace the
guard cover.
BREAKAWAY SWITCH
REMOVE THE SIX 3/8” BOLTS
IN THE CHAIN GUARD
To Next Page
