5. Sensitivity Parameters Setting
You may encounter the following problems during counting/sorting:
■ Machine doesn't sort the notes properly;
■ Machine frequently recognizes good notes as unfit notes;
Please contact your technician/dealer to have the machine’s sensitivity parameters adjusted.
In case of a technical problem that can’t be solved by operator, please contact your supplier.
Key Points:
■ If the room temperature is lower than 20℃, wait 3 minutes after turning the machine on before
operating.
■ The machine should be operated in a room with good ventilation, and kept away from strong
sunlight and/or magnetic field.
■ The machine must be plugged into grounded electric outlets ONLY.
■ The voltage must be in the range of 100~240V AC to avoid malfunction / breakage.
■ All external rollers and wheels must NOT be oiled or greased to avoid malfunction.
■ Dusts on CIS image detecting module, IR sensors, and magnetic sensor must be thoroughly
cleaned at least once a week. You may remove dust build-up on the exposed parts of the
machine with the brush provided.
NOTE: Do not use any chemicals to clean this machine.
Replacing the fuse
If the machine doesn’t turn on, it may be caused by a burnt fuse. Open the fuse cover holder,
and replace the fuse.
To Next Page