Operating
In order to avoid counting/detection errors, the following must be done before counting:
① Have the banknotes neatly stacked
② Straighten out folded notes/corners
③ Remove wrinkled notes
④ Remove any foreign objects from the notes (staples, coins)
Place the machine on a solid flat surface. Plug in the cord, and turn the machine on. Make
sure all connections are secure. If you have purchased an external display, connect it to the
RS232 port in the back of the machine. Avoid strong electromagnetic field or direct sunlight.
Note: In order to ensure personal safety, only use grounded electric outlets.
Turn on the power switch, the machine will display the software version first, then perform a
self-test.
If the test is successful, the machine will enter "ready" state (See figure 1). If some error
To Next Page
Loading...