Carrier TRANSICOLD Vector 8500 Operator's Manual

62-11646 28
M ANUAL D EFROST
1. With the system powered up (START/RUN-OFF switch in the START/RUN
position) press the MANUAL DEFROST key.
2. If the conditions for defrost are met, the status bar and the Box
Temperature display will change to the word “DEFROST”. The
MessageCenter will display “DEFROST CYCLE STARTED” for 10
seconds. At the completion of any defrost cycle, the MessageCenter will
return to the default display.
3. If the conditions for defrost are not met, the MessageCenter will display
“CANNOT START DEFROST CYCLE” for five seconds. This message will
be activated when:
• The box temperature is too warm. Defrost may be entered when the
defrost termination temperature sensor is below 40°F (4.4°C) or the
supply air temperature sensor is below 45°F (7.2°C), OR
• The engine has not run at least 15 seconds after starting, OR
• The unit is in Pretrip, OR
• There is an active shutdown alarm.
2
1
3
START/STOP DIESEL DEFROST
DEFROST CYCLE STARTED
DEFROST
SETPOINT
o
F
25

Carrier TRANSICOLD Vector 8500 Specifications

General

Brand	Carrier TRANSICOLD
Model	Vector 8500
Category	Automobile Accessories
Language	English