Carrier TRANSICOLD Vector 8500 Operator's Manual

62-11646 10
I NSPECT M ODE
Inspect mode provides an additional layer of safety for operators and
technicians. Inspect mode should be used during all pretrip inspections of the
unit.
Inspect mode is a user activated feature that forces the unit to shutdown and
remain in shutdown regardless of operating state.
After unit inspection, Inspect mode must be manually disabled, at which point
the unit will resume standard operation.
Inspect mode is not a substitute for proper Lockout/Tagout procedures, which
are always required when servicing the unit.
Enter Inspect Mode:
1. With the system powered up (START/RUN-OFF switch in the START/RUN
position) press the MENU key until INSPECT MODE is displayed.
2. Press the INSPECT MODE soft key, the unit will shut down.
START/STOP DIESEL COOL
BOX TEMPERATURE
o
F SETPOINT
o
F
INSPECT
MODE
34.3
34
EXIT
1
2

Carrier TRANSICOLD Vector 8500 Specifications

General

Brand	Carrier TRANSICOLD
Model	Vector 8500
Category	Automobile Accessories
Language	English