9. Place outer spring (Item 15) over sleeve.
10. Separately assemble seal housing cover (Item 2), packing gland gasket (Item 13), packing
gland (Item 14), and O-ring (Item 12).
11. Oil the contact sleeve and the O-ring and place the housing and gland assembly over the
sleeve.
12. Carefully depress the spring until snap ring (Item 11) can be attached to the sleeve.
13. Position key (Item 6) to complete the bench assembly.
14. Install seal housing cover gasket (Item 1) and cover assembly on the compressor.
15. Remove the snap ring.
16. Install shaft-end labyrinth gasket (Item 5) and labyrinth (Item 7).
17. Install windage baffle (Item 4). Attach snap ring to baffle for safekeeping.
To Next Page
Loading...
