10. Protect the shaft journal by wrapping it with clean, heavy paper or cardboard.
Reassembly
Bearing reassembly is basically a reversal of the disassembly procedures outlined above,
with the following additional steps.
Use extreme care when rolling out the lower bearing half. Keep the hands and fin-
gers well clear of any position where they might be caught by the bearing half if it
were accidentally released and rotated back to its bottom position. Serious per-
sonal injury could result.
WARNING
!
WARNING
CAUTION
CAUTION
!
Curil-T is the only approved compound for use in the assembly of the bearings
on this motor. Other products may harden and impede the operation.
To Next Page
Loading...
