About Advanced Features & Operation
29
ENERGY SAVING SMART FAN - This feature automatically de-energizes
the fan during an Unoccupied time period, except when necessary to heat
or cool (see page 28).
Note: The fan will not de-energize during an Unoccupied time period if it has
been programmed for continuous operation (step #7, page 20).
HEAT/COOL DIFFERENTIAL - The Heat and Cool setpoints will not be
allowed to come any closer to each other than the value set in Advanced
Setup step #9, on page 20. This minimum dierence is enforced during
Auto-changeover and Program On operation.
Note: To increase the spread between the heating and cooling setpoints
in the Auto-changeover mode press the MODE button until only the heat
setpoint is displayed; adjust to the desired setpoint. Press the MODE button
until only the cool setpoint is displayed; adjust to the desired setpoint. Press
the MODE button again to enter the Auto-changeover mode where both the
heat and cool setpoints are displayed.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
