Quick Start Set the Clock and Go
6
Press the MODE and FAN buttons at the same time
for two seconds to enter Setup screens.
During Setup and
Programming: Pressing
the UP or DOWN button
will modify the ashing
selection.
Tip: To change hours
quickly, press and hold
the FAN button and
press the UP or DOWN
button.
Press the MODE and FAN
buttons at the same
time to return to normal
operation.
The thermostat is preprogrammed from the factory to operate a 4 pipe system without
the need for further programming. To optimize the installation of this thermostat for a
2 pipe system, follow the instructions in the Advanced Setup section. Page 19
FAN
FAN
MODE
MODE
Setting the Clock
Setting the Day
MODE
Press
To adjust the
Clock or Day,
Use
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
