No. Part name Procedure Remarks
1
Suction
grille
CAUTION
Be sure to put on the gloves at disassembling
work; otherwise an injury will be caused by a
part, etc.
1. Detachment
1) Stop operation of the air conditioner and
then turn off switch of the breaker.
2) Slide the 2 knobs of the suction grille
inward and then hang down the suction
grille.
3) Remove a strap connecting the panel
and the suction grille and then remove
the suction grille.
2. Attachment
1)
Hook the suction grille to the panel.
2) Attach strap of the suction grille to the
panel as before.
3) Close the suction grille, slide the knobs
outward and then fix the panel
Suction grille Knobs of the
suction grille hook
Ceiling panel
Adjust
corner cap
Hook for
falling-preventive strap
Hole for
ceiling panel hook
Hinge
2
Electric
parts cover
1. Detachment
1) Carry out work of item 1. of 1.
2) Remove the fixing screw A which fix
the electric parts cover and loosen the
fixing screw B
3) Pull down the electric parts cover,
remove pin of the bell mouth and then
slide it to the arrow direction in order to
open the claws and the electric parts
box cover.
2. Attachment
1) Close the electric parts cover and slide
it, hook claw of the electric parts box,
claw of the electric parts box cover and
the Dharma doll hole, and then insert
pin of the bell mouth into hole of the
electric parts box cover.
2) Tighten the fixing screws A and B an
then fix the electric parts box cover
3) Following to work of item 2 of 1, mount
the suction grille as before.
Bell mouth pin Claw of
electric parts box
Sliding directionSliding direction
Fixing screFixing screw Bw B
Fixing screFixing screw Bw B
Potbelly hole otbelly hole
(Dhar(Dharma doll hole)ma doll hole)
ElectrElectric paric parts bots box cox coverer
Sliding direction
Fixing scre
w B
Fixing scre
w A
P
otbelly hole
(Dhar
ma doll hole)
ClaClaw of electrw of electricic
parparts bots box cox coverer
Electr
ic par
ts bo
x co
v
er
Cla
w of electr
ic
par
ts bo
x co
v
er
11.
DETACHMENTS
Indoor Unit
To Next Page
Loading...
