Carrier 40VMH024 - Page 28

28
Programmable Controller (40VM900003) — When
setting an address, connect only one wired controller to an
indoor unit.
1. Press FA N and BACK simultaneously for five seconds to
access the parameter settings as shown in Fig. 47.
Fig. 47 —Programmable Controller (40VM900003)
IDU Addressing Menu
2. Press TEMP. UP or TEMP. DOWN to move cursor, and
select IDU ADDRESSING. Select MENU/OK to access
this setting.
3. Press TEMP. UP or TEMP. DOWN to choose the
address you want to set. See Fig. 48. Press MENU/OK to
send this address to the IDU.
Fig. 48 —Programmable Controller (40VM900003)
Setting IDU Address
4. Press BACK twice or wait 30 seconds to automatically
exit the parameter settings menu.
MODE
NWOD .PMETNAF
MENU
TEMP. UP
OK
BACK
ON/OFF
MODE
NWOD .PMETNAF
MENU
TEMP. UP
OK
BACK
ON/OFF