Carrier 40VMH024 - Page 27

27
Wireless Remote Controller (40VM900001) —
Indoor unit addressing can be performed using the wireless
remote controller. When using the wireless controller, the
user must maintain a line of sight with the receiver on the
indoor unit. See Fig. 44 for a description of the buttons on
the wireless remote.
Fig. 44 —Wireless Remote Controller
(40VM900001)
Use a pin or a needle (or another small, sharp tool) to press and
hold LOCK for at least ten seconds, then press to activate.
Click or to select an address and press to send the
setting. To display an indoor unit address, use the same tool to
press and hold LOCK for at least 10 seconds, and press to
query the address.
Non-Programmable Controller (40VM900002) —
When setting an address, connect only one wired controller to
an indoor unit.
Press ROOM TEMP and SWING simultaneously for three
seconds. If there is no address for this indoor unit, the display
shows FE# 00. See Fig. 45. Otherwise, the display shows the
current address of the indoor unit.
Fig. 45 —Non-Programmable Controller
(40VM900002) IDU Addressing Menu
Click TEMP. UP or TEMP. DOWN to change 00 to the
desired address as shown in Fig. 46. Press OK to confirm, and
exit the setting interface.
Fig. 46 —Non-Programmable Controller
(40VM900002) Setting IDU Address
RESET
TIMER ON
TIMER OFF
CLOCK
SWING
AIR DIRECTION
OK
SWING
MODE
FAN
AUTO
COOL
DRY
HEAT
FAN
TEMP
SET
CLOCK
SET
HOUR
FAN SPEED
LOCK
C/H
2 – FAN SPEED SETTING
4 – ADJUST UP
6 – AIR DIRECTION
9 – CLOCK SETTING
10 – TIMER ON
11 – TIMER OFF
14 – OK (CONFIRM)
1 – MODE SETTING
3 – ADJUST DOWN
5 – ON/OFF
7 – AIR VERT. SWING
8 – AIR HORIZ. SWING
12 – RESET
13 – LOCK
15 – COOL/HEAT
FAN
MODE
MODE
FAN TEMP. DOWN
TEMP. UP
OK
ON/OFF
TIMER
ROOM TEMP.
SWING
#
#
MODE
FAN TEMP. DOWN
TEMP. UP
OK
ON/OFF
TIMER
ROOM TEMP.
SWING