Carrier 42XQA Series - Condensate and Pipe Routing; Condensate and Interconnection Pipe Routing

9
Depending on whether the unit is installed on the wall (console) or ceiling (underceiling), the
pipes for draining off the condensate and also the interconnection pipes must be routed
differently.
Fig. 11, 12 and 13 show the installations on the wall and ceiling and where these pipes must
be routed, as well as where it is necessary to break the indentation in the right-hand side
cover of the indoor unit.
4.3.5 DRAINING OF THE CONDENSATE
Fig. 11 - Drainage pipes for underceiling assembly
NOTE
Insulate the drainage pipe to a minimum
thickness of 5mm to prevent
into the device.
Fig. 13 - Indentations for pipe discharge
Fig. 12 - Drainage pipes for wall assembly