Carrier 42XQA - Setting the Operating Mode

SETTING THE OPERATING MODE
SETTING THE OPERATING MODE
“MODE” button
Pressing the “MODE” button causes the
operating mode to change. The “MODE”
button must be released and then pressed
again to switch to the next mode. The active
mode will always be displayed in normal
operation.
NOTE
If the “MODE” button is not
pressed for 15 seconds, the next
command always changes the
mode to OFF.
The available operating modes to select from
are:
Remote Refrigeration Only
OFF (disconnected)
COOL (refrigeration)
DRY (dehumidification)
FAN ONLY (ventilation)
OFF Mode
• OFF mode
• Ambient Temperature: if configured by
canceling the ambient environment
sensor. Otherwise none.
Available Buttons
• “MODE” button
COOL and DRY modes
• ICON of the Operating Mode.
• Ambient Temperature: if configured by
canceling the temperature sensor of the
ambient environment unit (operated by
the environment controller); otherwise the
temperature is selected by the user with
the “SET TEMP” icon.
• FAN/LOUVRE icon with the Fan and
Louver settings – air deflector – selected
by the user.
Available Buttons
• All the Buttons are available.
DRY
Dehumidification Operation
COOL
Refrigeration Operation
19