USING THE WIRELESS REMOTE CONTROL
USING THE WIRELESS REMOTE CONTROL
Connect / Disconnect
(Key B)
When the air conditioner is disconnected,
the control display shows only the hour of the
day (if other icons are shown, disconnect the
control by pressing the “ ”button).
Press the “ ”button to connect the unit. All
of the selected and saved functions light up;
the unit operates according to the functions
selected. Press the “ ”button to
disconnect the air conditioner. All of the
unit’s signals disappear and the control
display shows the current time only. If the
unit does not stop, connect the control (by
pressing the “”button) and repeat the
operation.
If the “”button is pressed immediately after
the disconnection of the unit, the unit only
starts operating again after 3 to 5 minutes
due to the protection against the frequency
cycle of the compressor.
The unit only emits the BEEP acoustic signal
when the orders have been received
correctly.
Select the Operating Mode
(Key A)
The operating mode of the air conditioner
can be selected with this button.
By pressing this button repeatedly, the
available operating modes are selected
sequentially. The unit recognizes the signal
received with a confirmation BEEP and the
operating mode selected is indicated as
follows:
Indicated symbol
Ventilation (fan only)
Cooling with dehumidification
Dehumidification only
Setting the desired temperature
Increase
(Key C)
Decrease
(Key D)
By pressing the buttons “ ” and “ ”,
you increase or decrease the desired
ambient temperature. With each touch of
the button, the unit emits the confirmatory
BEEP acoustic signal and the selected
temperature appears on the display.
The selected temperature may be between
17°C (63°F) and 32°C (90°F) at 1-degree
intervals.
NOTE
In cooling mode, if the temperature
selected is higher than the ambient
temperature, the unit will not start
operating.
11
To Next Page
Loading...
