Carrier 45MBDAQ18XA3 - Install the Indoor Unit; Step 1: Select Installation Location

45MBDAQ: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
13
A. INSTALL THE INDOOR UNIT
Step 1: Select Installation Location
NOTE: Before installing the indoor unit, you must choose an appropriate location. The following are standards that will help you choose an
appropriate location for the unit.
Proper installation locations must meet the following standards:
Fig. 6 —Installation Location Selection
NOTE: For models with a cooling capacity of 6K to 18K only apply to one room. If an 18K indoor unit is equipped with a metal fan wheel
metal drain pan and fireproof sheet metal, it can supply multiple rooms.
Enough room exists for
installation and maintenance.
Enough room exists for the
connecting the pipe and drainpipe.
The ceiling is horizontal and its structure can
sustain the weight of the indoor unit.
The air inlet and outlet
are not blocked.
7KHDLUÀRZFDQ¿OO
the entire room.
DO NOT
install unit in the following locations:
Areas with oil drilling or fracking
Coastal areas with high salt content in the air
Areas with caustic gases in the air, such as
hot springs
Areas that experience power fluctuations, such
as factories
Enclosed spaces, such as cabinets
Kitchens that use natural gas
Areas with strong electromagnetic waves
$UHDVWKDWVWRUHÀDPPDEOHPDWHULDOVRUJDV
Rooms with high humidity, such as
bathrooms or laundry rooms



 
There is no direct radiation
from heaters.

For North America, models with a cooling capacity of 6000Btu to 18000Btu only apply to one room.