Carrier 48/50PD05 - Page 102

102
Table 65 — MODE - CONFIGURATION (cont)
ITEM EXPANSION RANGE UNITS DEFAULT
CCN
TABLE/SUB--- TABLE
CCN POINT ENTRY
HEAT Heating Configuration HEAT_CFG
HT.TY Type of Heat Installed 0=No Heat
1=Gas
2=Electric
0(50serieswithno
electric heat)
1(48series)
2(50serieswith
electric heat)
HEATTYPE
N.HTR Number of Heat Stages 1to2 1 (50 series <15kW)
2(48series,50
series >=15kW)
NUM_HEAT
MRT.H Heat Minimum On Time 60 to 999 sec 120 HMIN_ON
MOT.H Heat Minimum Off Time 60 to 999 sec 120 HMIN_OFF
H.DEC Heat Stage Decrease
Time
120 to 999 sec 300 HSTAGDEC
H.INC Heat Stage Increase Time 120 to 999 sec 450 HSTAGINC
FOD.E Fan--- off Delay, Elect Heat 10 to 600 sec 30 ELEC_FOD
FOD.G Fan--- off Delay, Gas Heat 45 to 600 sec 45 GAS_FOD
HT.LO Heating Lockout Temp 40 to 125F dF 75 OATLHEAT
SAT SUPPLY AIR
TEMPERATURE
SAT.H SAT Heat Mode Sensing Enable/Disable Disable SAT_HEAT
SAM.L Maximum SAT Lower
Level
85 to 200 dF 140 SATMAX_L
SAM.U Maximum SAT Upper
Level
85 to 200 dF 160 SATMAX_H
SPT SPACE TEMPERATURE
HT.PD SPT Heat Demand (+)
Level
0.5 to 5 ^F 1 HDEM_POS
HT.ND SPT Heat Demand (--- )
Level
--- 5 t o --- 0 . 5 ^F --- 1 HDEM_NEG
H.LAG Heat Thermal Lag Factor 0to5 min 1 HEAT_LAG
ECON Economizer Configuration ECON_CFG
EC.EN Economizer Installed Ye s/No No: no FIOP
Yes: FIOP
ECONO
E.CTL Economizer Control Type 1=Dig/Position
2=Dig/Command
3=Analog Ctrl
1 ECON_CTL
MP.25 Econ Min at 25%
Fanspeed
0 to 100 % 0 MINP_25
MP.50 Econ Min at 50%
Fanspeed
0 to 100 % 0 MINP_50
MP.75 Econ Min at 75%
Fanspeed
0 to 100 % 0 MINP_75
MP.MX Econ Min at Max
Fanspeed
0 to 100 % 30 MINP_MAX
EC.MX Econo Cool Max Position 0 to 100 % 100 ECONOMAX
M.ANG Min Actuator Ctrl Angle 75 to 90 88 MINANGLE
EH.LO Econo Cool Hi Temp Limit 40 to 100F dF 65 OATLECLH
EL.LO Econo Cool Lo Temp Limit --- 30 to 50F dF 0 OATLECLL
DF.DB Diff Dry Bulb Control Disable/Enable Enable DIFFBULB
UEFC Unoccupied Free Cooling 0=Disabled
1=Unoccupied
2=Preoccupancy
2 UEFC_CFG
FC.TM Free Cool PreOcc Time 1 to 9999 min 120 UEFCTIME
FC.LO Free Cool Low Temp Limit ---30 to 70F dF 50 OATLUEFC
PE.EN Power Exhaust Installed Yes/No No: no FIOP
Yes: FIOP
PE_ENABL
PE1.C Power Exhaust Stage1
CFM
100 to 15000 cfm 600 PE1_CFM
PE2.C Power Exhaust Stage2
CFM
100 to 15000 cfm 0 PE2_CFM
IDF.C Indoor Fan Max Speed
CFM
500 to 15000 cfm 1600 (05)
2000 (06)
IDF_CFM
EN.SW Enthalpy Switch 0=No Switch
1=Normal Open
2=Normal Closed
0: no FIOP
1: FIOP
ENTHLCFG
48/50PD