45
Step 12 — Install Accessories
Available accessories include:
Roof Curb
Thru--base connection kit (must be installed before unit
is set on curb)
Manual outside air damper
Two--Position motorized outside air damper
EconoMi$er IV (with control and integrated barometric
relief)
EconoMi$e r2 (without control/for external signal and
integrated barometric relief)
Power Exhaust
Differential dry--bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
Time Guard II compressor a nti--cycle cont rol
Outdoor coil hail guard
Outdoor coil protector grille
Head pressure control
Programmable setback thermostat
Electrical/Mechanical thermosta t and subbase
Thermidistatt device
Humidistat
Electric Heaters
Single Point kits
Thermostat / Sensors
CO
2
sensor
DDC interface (PremierLink)
Louvere d hail gua rd
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
Pre --Start and Start--Up
This completes the mechanical installation of the unit.
Refer to the unit’s Service Manual for detailed Pre--Start
and Start--up instructions.
50TCQA
To Next Page
Loading...
