[
</
[95
!
II
CON;)
¢0 N\
_/94 0 _4080
[ ,_] 16 06]
\\
°1o
REQUIRED CLEARANCE TO COMBUSTIBLE MATE
INCHES [rnm]
TOP QF UNIT ......................................................................................... 0
DUCT SIDE QF UNIT ............................................................................. 0
SIDE OPPOSITE DUCTS ...................................................................... 0
BOTTOM OF UNIT ................................................................................. 0
NEC. REQUIRED CLEARANCES.
INCHES [mini
BETWEEN UNITS, POWER ENTRY SIDE .................................... 42.00 [1666.8]
UNIT AND UNGROUNDED SURFACES, POWER ENTRY SIDE .36.00 [914.01
UNIT AND BLOCK OR CONCRETE WALLS AND OTHER
GROUNDED SURFACES, POWER ENTRY SIDE ......................... 42.00 [1066.8]
REQUIRED CLEARANCE FOR OPERATION AND SERVICING
INCHES [mm]
CONDENSER COIL ACCESS SIDE .............................................. 36.06 [762.01
POWER ENTRY SIDE .................................................................... 36.08 [762.0]
(EXCEPT FOR NEC REQUIREMENTS)
UNIT TQP ....................................................................................... 48.0011219.21
SIDE OPPOSITE DUCTS .............................................................. 36.00 1762.0]
LEGEND
NEC National Electrical Code
NOTES:
1. Clearances must be maintained to prevent recirculation of air from outdoor-
fan discharge, with the exception of the condenser coil (36.00 in [914.0 mini. A
removable fence or barricade requires no clearance.
2. Dimensions are in inches. Dimensions in [ ] are in millimeters.
BI OWER, CONTROl BOX AND EVAP COli
ACC{SS PANEL
COMPRESSOR PANEL \
\\\\\\
FIELD ENTRY TO\
SERVICE PORTS _\
\\\
UNIT
50ZH030
LEFT SIDE VIEW
FRONT VIEW
26.772
[10540]
'°6 k ; L6,.,,2.,o,[I 20] _1]
I.D. x 12.7 DEEP
RIGHT SIDE VIEW
C00156
ELECTRICAL CHARACTERISTICS
208/230-3-60
UNIT WEIGHT
Ib kg
254 116
CENTER OF GRAVITY IN. (MM)
X Y Z
14.0 (358) 18.0 (483) 12.0 (305)
Fig. 2--Unit Base Dimensions--5OZH030
To Next Page
Loading...
