EasyManua.ls Logo

Carrier AquaEdge 19DV series - Page 78

Carrier AquaEdge 19DV series
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
78
APPENDIX D — REMOVE CONNECTIVITY COMMISSIONING (cont)
Table A — Customer Gateway Data Submittal Information
Submittal Data: Fill out all white fields. Scan or photograph
and submit per Customer Gateway instructions.
3. Verify that both power wiring and connection to router is
intact. Verify that a SIM card is installed in the modem.
See Fig. F for connections.
Fig. F — Modem Connections
4. Install the provided antenna and route through knockout
in back of control panel. Be sure to observe the warning
in Fig. G.
Fig. G — Arc Flash Warning
5. Apply appropriate protective personal equipment (PPE)
and apply power to unit and verify that modem and router
are powered by confirming power LEDs are on.
6. Wait approximately 5 minutes before proceeding to next
step to allow communication to be fully initiated.
CHILLER INFORMATION
#
Parameter Write Values Below Description
1.1
PIC5 Software
Part Number
____________________ Shown at bottom of start-up screen, or in the menu under Configuration > Control Identi-
fication. E.g. SCG-SR-20M200400
1.2
Chiller Model
Number
____________________ E.g. 19DV-G4CG4C4425H4-
1.3
Chiller Serial
Number
____________________ E.g. 5217Q28248
GATEWAY INFORMATION
#
Parameter Write Values Below
2.1
Modem
information
Modem serial number e.g. “2017N089911:
Modem S/N: ____________________
2.2
STATUS LED SIGNAL LED Color (per Table B) – (circle one): RED / YELLOW / GREEN
STATE (circle one): SOLID / FLASHING
CHILLER CONTROLLER INFORMATION
Parameter Value Description
3.1
BACnet
Identifier
_________________________ Seven digits e.g. 1600001 (from Customer Gateway).
3.2
IP Address ____.____.____.____ This is the IP address with which the PIC5 is configured (from Customer Gateway).
SITE INFORMATION
#
Parameter Value Description
4.1
Jobsite Name _____________________ This is the name by which the jobsite is usually recognized. It will be used to distinguish
the site in the monitoring system.
4.2
Jobsite Address _____________________
_____________________
Full address of jobsite. Used to uniquely identify jobsites in case Jobsite Name is dupli-
cated.
4.3
Service Office _____________________ Name of service office that services this site.
4.4
Service Office
Contact
_____________________
_____________________
_____________________
Name and Telephone Number (or e-mail address).

Table of Contents

Other manuals for Carrier AquaEdge 19DV series

Related product manuals