NOTES:
1.
147 8:57 O]
Unit must have clearances as follows:
Top -- Do not restrict.
Sides and End -- 6' from solid surface.
2. All pumps have drains located at the
bottom of volute for draining.
3. Temperature relief devices located on
suction line, liquid line and filter drier of
each circuit and have 1/4" flare
connection.
4. Units without a pump package have
the same leaving water connection, Y
and Z dimensions, (entering water)
and Pump Discharge X dimensions as
units with a pump package.
5. Dimensions are in mm [inches].
SERVICE AREA 1219 2{48 6] FROM EACH SiDE OF THE UNIT
COOLER
SERVICE ARE
P8 z
RE
296 46
[]1 67}
COOLER
45663
117981
PSr
LPUNP PACKAGE
ENTER:RG WATER
P5 -_ 4" VICIAULIC
'_"_ 147982 u_:r NOUNTINO
15826]
2393 08
19422}
{SEE NOTE 4)
_SEE DETAIL A
/
W
c 586 88
115 23]
51892
{2645]
45668
[1798}
SCROLL:NG EAROUEE_
DISPLAY \
R:EL# CONTROL WIR[NG_
t
86400
[3402}
AIR FLOW
I
I1 n
1970
184850_
UNIT MOUNT[NG
POWER BOX 238V
_80NFRO[/POWER BOX
380V,460V575V
7/8 ¸' _NOCKOUT TO 8E
/USED roR LOCATING
F:£LD POWER W/R:NG
198¸00
I[ {7 481
-- $36 5O
E18 85i
_ 40 _5
[_5R_
Fig. 3 -- 30RB080 Air-Cooled Chiller Dimensions
To Next Page
Loading...