4_
NOTES:
1. Unit must have clearances as follows:
Top -- Do not restrict.
Sides and End -- 6' from solid surface.
2. All pumps have drains located at the bottom of volute
for draining•
3. Temperature relief devices located on suction line, liq-
uid line and filter drier of each circuit and have 1/4"
flare connection•
4. Units without a pump package have the same leaving
water connection, Y and Z dimensions, (entering
water) and Pump Discharge X dimensions as units
with a pump package.
5. Dimensions are in mm [inches]•
i 4
F
I
SERVICE AREA 121921480] FRO_ EACH SIOE Of INE UNIT
860 g3
[33895]
L
©
DEIML A
SCAL[ 1:2
AIR LOW
i i °
I--
/
I J
246 36
i9 70i
18465] ii 59i
4077 i 491!
1849 i 2228
[17 98]
WEIG!O iMAX WEIGHIi CENTER or GRAVITY PUMP S_CTION (PS} PUMP 8iSCHARGE (PD)
cuJcu_cu_cu_Hi c<_ ..........
Ib/Rg i ib/k9 iIM ilNCH] M_ lINCH] iX25 iY25 _L25 _XP§ _YP§ _LP§
4ss4i Tigi Fq%] ............T_B_..... \_s
#
5810 48r 6 188 o
i97S i 2353 i_4582] [4086] [_
]
4560 i 5393 i 1_65 i0!3 6756 3099 353i 381 0 482 6 /880
2068 I 2446 i _48 86] [39 88_ [?6 6] [I_2} [!]9i [!50] [!90] [7 4]
i [5826} i [179B]
PSx i?1490 _1
[6752] i
8393¸O8 _4
i9422]
Fig. 2 J 30RB060, 070 Air-Cooled Chiller Dimensions
To Next Page
Loading...