8.2.2
Checking Engine Oil Level
1. Turn the APU OFF and wait at least 5
minutes to allow the engine oil to return to
the oil pan.
2. Remove the dipstick (shown in red) from
the engine.
3. Wipe the dipstick with a clean cloth.
4. Reinsert the dipstick and remove the
dipstick again.
5. Check to see that the oil level is between
the two marks. If the oil level is below the
lower mark, add oil to the engine through
the fill cap located to the right of the
dipstick.
6. After checking the oil level, reinsert the
dipstick.
Do not over fill engine oil or operate
APU if oil level is below lower mark
To Next Page
Loading...
