Setpoint
1. Press the [C/F – Prog] button again. The setpoint will flash.
Note: If the thermostat is configured to have two setpoints, first adjusts
the setpoint for cooling and then the setpoint for heating.
2. Use the [+] and [-] buttons to select the system mode of the first event.
Follow the steps above for the other schedule events of the same day
(Prog 2 for two events per day, or Prog 2, 3 and 4 for four events per day).
Follow the steps above for all the other days.
- 17 -
Weekly program (cont.)
To Next Page
Loading...
