Carrier Extra XT - Starting Unit - Manual Continuous Run

6
62--10601
STARTING UNIT - MANUAL (CONTINUOUS RUN ONLY)
FAULT STAND-BY
FUNCTION
CHANGE
UNIT
DA TA
PRETRIP
CHECK
AUTO S/S
CONTINUOUS
MANUAL
DEFROST
ENTER
SETPOINT BOX TEMPERATURE
FAULT
STANDBY
POWER ON
1
0
START/RUN
OFF
STANDBY
ENGINE
M
MM
MA
AA
AN
NN
NO
OO
OP
PP
P
Side of Control Box
4. Hold GLOW/CRANK switch in the GLOW position for
5 to 15 seconds (see chart on next page). Then hold
the GLOW/CRANK switch in the CRANK position for
up to 10 seconds to start the diesel engine.
1. Place ST
A
RT
/
RUN - OFF switch to the ST
A
RT
/
RUN
position. If STAR T/STOP is displayed, press AUTO
S/S-CONTINUOUS toggle key to place unit in Continuous
Run Mode .
2. Press FUNCTION CHANGE key until AUTO OP or
MAN OP is displayed. If MAN OP appears, unit is in
manual start mode.
3. If AUTO OP appears, first press ENTER key, then
UP or DOWN arrow key until MAN OP is displayed.
Press ENTER key to lock in manual mode.
5. With MAN OP selected, press
AUTO S/S-CONTINUOUS key
to toggle between Auto
Start-Stop and Manual
Start/Continuous Run modes.