GB - 7
ENGLISH
Fan only
1
2
3
If the air conditioner is to be used in the
fan only mode (ventilation) the ends of
the flexible hose should be inserted in
the appropriate holes at the rear of the
unit as shown.
Plug the unit in.
Open the air flow direction guide vane.
Turn the mode selector to the high or
low fan speed symbol.
4
5
The fan speed indicator light on the
control panel is illuminated.
The unit will now operate in the fan
only mode.
The room air is drawn in through the
side grilles of the air conditioner,
filtered and cleaned and then returned
to the room through the front and rear
air supply grilles.
Cleaning
Periodically clean the air filters in the
sides of the unit.
To pull out the filters from their position
use the tab on the outside edge.
To clean the filters use a vacuum
cleaner…
then rinse and dry the filters.
Reinsert the filters correctly in their
position.
To clean the appliance use only a damp
cloth and soap.
Never use spray or flammable liquids.
If the unit is not used for extended
periods:
• Empty the remaining condensate
water through the drain tube at the
back of the unit.
• Clean the filters.
• Insert both ends of the flexible
hose into the appropriate holes.
• Cover the air conditioner
with a bag.
PETROL
To Next Page
Loading...
Need help?
General
