8 Specifications subject to change without notice. OM-KSACN0901-02
INITIAL SETUP
Set the current day and time
NOTE: The Wired Controller can be powered
ON or OFF during this step.
1. Press TIMER for 2 seconds or more to set
the current date and time. The TIMER display
flashes (see Fig 5).
Fig. 5 —Timer
2. Press the UP or DOWN arrow (Fig. 6) to
set the week day; the selected week day
will flash (Fig. 7).
Fig. 6 —Up or Down Arrows
Fig. 7 — Days of the Week
3. Press TIMER to confirm. If there is no
button pressed within 10 seconds, the
displayed week day will be saved.
4. Press the UP or DOWN arrows (Fig. 6) to
set the current time. Press repeatedly to
adjust the current time in 1-minute
increments. Press and hold to adjust the
current time continuously. Press TIMER to
confirm. If there is no button pressed within
10 seconds the displayed time is saved.
Fig. 8 — Week Day and Time
5. Time scale selection: Press TIMER (see
Fig. 5) and DAY OFF (Fig. 9) for 2 seconds
to alternate the clock time display between
the 12 hour and 24 hour formats.
Fig. 9 — Timer
To Next Page
Loading...
