High Wall Type
Installation Manual
–21–
 
10 Applicable Controls
A wired remote control is necessary for this function. This function cannot be operate with a wireless remote 
control.
REQUIREMENT
• When this air conditioner is used for the first 
time, it takes approx. 5 minutes until the remote 
control becomes available after power-on. This 
is normal.
<When power is turned on for the first time 
after installation> 
It takes approx. 5 to 10 minutes until the 
remote control becomes available.
<When power is turned on for the second (or 
later) time> 
It takes approx. 3 to 10 minute until the remote 
control becomes available.
• Normal settings were made as factory default. 
Change the indoor unit settings as required.
• Use the wired remote control to change the 
settings.
 Changing applicable control 
setting
Basic procedure for changing settings
Change the settings while the air conditioner is not 
working.
(Stop the air conditioner before making settings.)
Procedure 1
Push   button and temp. setup   button 
simultaneously for 4 seconds or more.
After a while, the display flashes as shown in the 
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push   button to 
erase the display content, and repeat the 
procedure from the beginning. 
(No operation of the remote control is accepted 
for a while after   button is pushed.)
(While air conditioners are operated under the 
group control, “ ” is displayed first.
When   button is pushed, the indoor unit 
number displayed following “ALL” is header unit.)
* The settings cannot be changed using the 
wireless remote control, simple wired remote 
control, or central control system. Therefore, 
install the wired remote control to change the 
settings.
Approx. 5 to 10 minutes
Power 
on
“SETTING” 
flashes
“SETTING” 
goes out
Remote 
control is 
available
Approx. 3 to 10 minutes
Power 
on
“SETTING” 
flashes
“SETTING” 
goes out
Remote 
control is 
available
1
6
1
3
2
5
4
 
(* Display content varies with the 
indoor unit model.)
21-EN
+001111053901_00Ta.book  Page 21  Monday, January 17, 2011  11:35 AM