High Wall Type
Owner’s Manual
–12–
EN
6 Hi POWER display
Displayed when the high power operation starts.
Press the Hi POWER button to start and press it
again to stop the operation.
7 (PRESET) display
Displayed when memorizing the preferred operation
mode or when it has been memorized.
Also, this icon is indicated when the memorized
preferred operation is displayed.
8 (COMFORT SLEEP) display
Displayed during the OFF timer operation that
automatically adjusts the room temperature and the
fan speed. Each time the COMFORT SLEEP button
is pressed, the display changes in the sequence of
1h, 3h, 5h, and 9h.
9 (QUIET) display
Displayed during the quiet operation.
10Swing display
Displayed during the swinging operation where the
horizontal louver automatically moves up and down.
NOTE
When both wired remote control and wireless
remote control are used, display on the screen of
wireless remote control may differ from the actual
operation in some cases.
Preparation and check before
use
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (R03 [AAA]) following the (+)
and (-) positions.
Batteries
• To replace the batteries, use two new batteries
(R03 [AAA]).
• In normal use, the batteries will last about one
year.
• Replace the batteries if there is no receiving
beep from the indoor unit or when the air
conditioner cannot be operated using the remote
control.
• To avoid malfunctions by battery leakage,
remove the batteries when not using the remote
control for more than one month.
1
7
5
4
6
9
8
12
3
A
C
L
12-EN
+001111053801_00Ta.book Page 12 Friday, January 21, 2011 3:52 PM
To Next Page
Loading...
