High Wall Type
Owner’s Manual
–21–
 
CAUTION
• The FIX and SWING buttons will be disabled 
when the air conditioner is not in operation 
(including when the ON timer is set).
• Do not operate the air conditioner for long 
hours with the airflow direction set downward 
during the cooling or dry operation.
Otherwise, condensation may occur on the 
surface of the vertical airflow louver and cause 
dew dripping.
• Do not move the vertical airflow louver 
manually. Always use the FIX button.
If the louver is moved manually, it may 
malfunction during operation.
If the louver malfunctions, stop the air 
conditioner once, and restart.
• When the air conditioner is started immediately 
after it was stopped, the vertical airflow louver 
might not move for 10 seconds or so.
• Louver operation is limited when performing 
group control. (Refer to “7 Limited Operation by 
Group Control”)
 Adjust the horizontal airflow
Preparation
• Take hold of the lever on the horizontal airflow 
louver and move them to adjust the airflow 
direction as required.
• The airflow can be adjusted at the left, and right 
locations of the louver.
21-EN
+001111053801_00Ta.book  Page 21  Friday, January 21, 2011  3:52 PM