2. DISPLAY AND BUTTONS
04
03
2.1 DISPLAY
2.2 BUTTONS
On/Off
Press to start operation.
Press again to stop.
Mode
Press the mode button to
switch the mode in turn.
ECO Sleep
My Mode
Press to memorize or resume
your favorite pre-settings.
LED
LOCK
Fan Speed
Press to select the fan speed.
Temperature UP
Increases temperature in
1 C increments.
Max. Temp. is 30 C .
Press to turn on/off the LED
display. Pressing 5 more
seconds to alternate the indoor
display between setting
temperature and room
temperature(Model dependent).
Press to enter Sleep Mode.
Decreases temperature in 1 C
increments. Min. Temp. is 17 C.
Temperature Down
Swing
ECO
Sleep
My
Mode
NOTE: HEAT mode is not supported
by the cooling only appliance.
SET
OK
Used to confirm the selected
functions.
TIMER
Set timer to turn unit on or off.
Clean
Used to start/stop the Self Clean
or Active Clean function.
(Model dependent).
Press together Clean button and
Turbo button at the same time more
than 5 seconds to activate Lock
function.
LOW
MED
HIGH
AUTO
MODEL:RG10B2(U)/BGEF
RG10B10(U)/BGEF(20-28 C)
RG10B2(U)/BGCEF(
(
Cooling only models, AUTO mode and
HEAT mode are not available
)
Starts and stops the horizontal louver
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).
Information are displayed when the remote controller is powered up.
Transmission Indicator
MODE display
TIMER ON display
FAN SPEED display
TIMER OFF display
Silence feature
display
ECO display
GEAR display
LOCK display
Temperature/Timer/Fan speed
display
Sleep mode display
Follow me feature display
Wireless control feature display
(some units)
Low battery detection display(If flashes)
Note:
All indicators shown in the figure are for the purpose of clear presentation. But during the actaul
operation, only the relative function signs are shown on the display window.
Displays when LOCK feature
is activated.
Lights up when remote
sends signal to indoor
unit
Displays selected fan speed:
Displays the current
including:
mode,
This fan speed can not be
adjusted in AUTO or DRY
mode.
Displays when ECO
feature is activated
Displays the set temperature
by default, or fan speed or
timer setting when using
TIMER ON/OFF functions.
Temperature range:
o
o
17-30 C/20-28 C
Timer setting range:
0-24 hours
This display is blank when
operating in FAN mode.
(Model dependent)
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Turbo
Enables unit to reach preset
temperature in shortest possible time.
Scrolls through operation
functions as follows:
Fresh( ) Follow Me( )
AP mode( ) Fresh....
The selected symbol will flash on
the display area, press the OK
button to confirm.
To Next Page
Loading...
