Carrier split room air conditioner remote control - Timer Operations; Timer ON;OFF Setting

11
12
Example of Timer setting
TIMER OFF
Stop
On
23:00
TIMER ON
Start
Off
6:00
When you select the timer operation, the remote controller automatically
transmits the timer signal to the indoor unit at the specified time.
Therefore, keep the remote controller in a location from which it can
transmit the signal to the indoor unit properly.
The effective operation time set by remote controller is limited in 24 hours.
CAUTIONS
1. TIMER button
Press the TIMER button as required. The current
timer setting is displayed alongside either the
TIMER ON or TIMER OFF indicator, and will flash.
2. TEMP. Buttons
Press to set the desired time.
Forward
Backward
Each time you push these buttons, the time moves
forward or backward by 10 minutes depending on
which direction you press. The time alters as
quickly as you press the button.
3. After setting the timer for TIMER ON and TIMER
OFF, check the TIMER indicator on the display
panel of the indoor unit is illuminated.
4. Cancel button(CANCEL)
Press the CANCEL button to cancel the timer
setting.
Preform steps 1, 2 and 3 to change the settings.
.
.
.
Canceling
Changing
.
.
Timer operation
1
2
Ca rri er
MODE
FAN SPE ED
TEMP.
AIR DI RECTION
SWIN G
LED
SLEE P
TURB O
CLOC K
TIME R
CANC EL
RESET
F/C
AUTO
SET TEMP.
SPEED
AUTO
ON
OFF
CLOCK
TIMER ON
TIMER OFF
(Timer Stop Operation)
The TIMER OFF feature is useful when you want
the unit to turn off automatically after you go to
bed. The air conditioner will stop automatically
at the set time.
To stop the air conditioner at 23:00 p.m.
1. Press the TIMER button until the TIMER OFF
indicator is displayed and the setting time beside
is flashing (if the displayed time is just 23:00,
3 seconds later, the TIMER OFF function will
be activated automatically).
2. Use the TEMP. button to display "23:00"
beside the TIMER OFF indicator.
3. This function will be activated 3 seconds
after you release the TEMP. button.
TIMER OFF
Example:
(Timer Start Operation)
The TIMER ON feature is useful when you want
the unit to turn on automatically before you return
home. The air conditioner will automatically start
operating at the set time.
IMPORTANT: The time will be registered in 3
seconds period (after pressing the TEMP. button),
so you should continue pressing the button until
the desired time is established. Otherwise you
must repeat the steps again.
To start the air conditioner at 6:00 a.m.
1. Press the TIMER button, the TIMER ON
indicator is displayed and the setting time
beside is flashing(if the displayed time is just
6:00, 3 seconds later, the TIMER ON function
will be activated automatically).
2. Use the TEMP/TIME button to display "6:00"
beside the TIMER ON indicator of the remote
controller.
3. Wait for 3 seconds and the setting time stops
flashing and this function is activated.
TIMER ON
Example: