ELECTRICAL SCHEMATIC WIRING DIAGRAM
This section contains Electrical Schematic Wiring Diagram covering the Models listed in Table 2-1 The following
Under no circumstances should ether or any other starting aids be used to start engine.
Under no circumstances should anyone attempt to repair the Logic or Display Boards! Should a
Observe proper polarity when installing battery, negative battery terminal must be grounded.
disconnect positive battery terminal when charging battery in unit. Connecting charger in reverse
will destroy the rectifier diodes in alternator.
than the connector terminals where the harness attaches. Microprocessor components operate at
different voltage levels and at extremely low current levels. Improper use of voltmeters, jumper
wires, continuity testers, etc. could permanently damage the processor.
In certain cases, the human body can have enough static electricity to cause resultant damage to