248
APPENDIX G — UPC OPEN CONTROLLER (CONT)
Local access to the UPC Open
Field Assistant is a PC-based software program that provides
the highest level of access for setting up and commissioning
the UPC controller. The PC can connect to the UPC through an
IP network or the Rnet access port on the controller using a
USB Link cable.
See the Field Assistant Help Guide for additional information
on setting up and using Field Assistant.
For a more user friendly interface, the Carrier i-Vu
®
Equipment
Touch and Equipment Touch app can be used to interface with the
UPC controller for set up and commissioning. See Fig. AE for
Equipment Touch connection details.
NOTE: The Equipment Touch and Equipment Touch App pro-
vide a lower level of access than Field Assistant. Some config-
uration items may not be able to be performed without Field
Assistant.
See the Equipment Touch Installation and Setup Guide or the
Equipment Touch App User Guide for details on connecting
and using an Equipment Touch or Equipment Touch App.
Contact your local Carrier sales office to order an Equipment
Touch or a USB Link cable for use with Equipment Touch App
or Field Assistant.
Fig. AE — Equipment Touch Connection
To Next Page
Loading...
