EasyManua.ls Logo

Carrier XCT 7 40VD H-7S Series - Maintenance

Carrier XCT 7 40VD H-7S Series
161 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
*The air cleaner should be cleaned only when it is switched o󰀨 and disconnected from the power supply,
otherwise electric shock and injury may appear.
Cleaning the air outlet port and the shell:
Cleaning The Filter
Attention
• Do not use gasoline, benzene, diluents, polishing powder or liquid insecticide to clean them.
• Do not clean them with hot water of above 50°C to avoid fading or distortion.
• Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special cookware detergent on the air
inlet grid, and then clean it with water after 10 minutes.
(A) remove dust with a vacuum cleaner.
(B) for excessive dust, use a soft-hair brush and a mild detergent to clean.
(C) Allow lter to dry fully before reinstalling.
• Wipe them with soft dry cloth.
• Water or neutral dry cleanser is recommended if the dust cannot be removed.
Attention
• Do not clean with hot water of over 50°C to avoid fading or distortion.
• Do not dry on the re, or the cleaner might cause re.
4
ENGLISH

Related product manuals