Carrier ZS Series - To make the zone warmer or cooler; To override the schedule

ZS Pro Sensor
ZS Zone Sensors CARRIER CORPORATION ©2020
User Guide All rights reserved
7
To make the zone warmer or cooler
1 From the Home screen, press the or button to show the Setpoint Adjustment screen. This screen
typically shows one of the following:
NOTE The control program may not show the
cooling and heating setpoint on this screen.
2 Press the or button to adjust the zone temperature setpoint. The control program determines how
much you can adjust the setpoint.
3 Wait a few seconds until the display returns to the home screen before you press any other buttons.
To override the schedule
Timed override to an occupied state
1 Press the button one time to override the schedule and put the zone in an occupied state for a length of
time specified in the control program's Increment field.
2 Press the button to incrementally increase the time. The maximum length of time that you can override
the schedule is specified in the control program's Maximum Duration field.
3 Wait a few seconds until the display returns to the home screen before you press any other buttons.
During the override, the bottom of the display shows the time (minutes) remaining in the override and an
hourglass to indicate the override state.