ZS Pro Sensor
ZS Zone Sensors CARRIER CORPORATION ©2020
User Guide All rights reserved
8
NOTES
If programmed, you can override the schedule for an indefinite amount of time. To do this, press the
button one time, then press the button until the display shows 999. The override remains in effect until
the schedule transitions to occupied or until you cancel it.
To cancel an override and return control to the schedule, press the button twice.
Force to an unoccupied state
If allowed by the control program, press and hold the button for 3 seconds to force the zone to an unoccupied
state.
Press the button again to cancel the force to unoccupied and return control to the schedule.
NOTE You may see the energy-saving icon if the control program specifies it.
To lock the sensor buttons
Simultaneously press and hold the 2 buttons shown below for 5 seconds to lock the sensor's buttons. The display
shows a lock icon to indicate the locked state.
Press and hold the 2 buttons again for 5 seconds to unlock the buttons.
NOTE If you press the button slightly before the button, the sensor will go into an override state instead of
locking the buttons. But, if you press the button first, the buttons will lock.
To Next Page
Loading...
