SERVICE INFORMATION
X. Front Hubs
a. Check seals for rips or tears and replace if any exist.
b. Inspect bearings for ease of movement. If bearings
are dirty or muddy, wash them in cleaning
solvent and spin with your finger. Never spin them vith compressed.
c. Apply an ample amount of grease to the bearing and
reinstall with bearing tool, making
sure it goes in straight: Damage to the hub can occur.
d. Install seals into hub. It is recommended to apply a
small amount of grease to the lip of the
seal. If the retention spring is in bad shape, replace the seal with a new one.
39
To Next Page
Loading...
