20. REAR FENDERS
a. Behind each seat is a mounting post for the rear
fenders.
b. Align the holes and slots of the fender bracket
with those of the mounting post.
c. Tighten with 10mm wrench.
21. SEATS AND SEAT BELTS
a. Remove the seat hardware from the hardware box. This will be the silver bolts, nuts and
washers.
b. The seat belts are shipped bolted together. It is easier to install the seat belts with them
separated.
c. Start on the driver side by bolting the outer end of the seat belt to the seat belt mount
located behind the driver seat and in front of the rear fender.
d. With the driver seat turned upside down, slide the seat adjusters all the way back.
e. Put the seat in place by aligning the front brackets and rear holes.
f. Insert a bolt in each hole from top to bottom leaving
the head of the bolt in the seat adjuster track.
g. You will have to hold the top of the bolt with a flat
head screw driver. Wedge the flat head screw driver
between the bolt head and the seat adjuster track and
tighten with a 12mm wrench.
h. Feed the seat belt through the holes in the top of the
seat.
i. Bolt the top seat belt bracket to the seat belt mount
located directly behind the drivers head.
j. Follow the same steps with the passenger seat. The
bolts for the passenger seat will be inserted from
bottom to top because the passenger seat does not
have an adjuster.
k. Tighten the passenger seat bolts with a 10mm
wrench.
l. Tighten the seat belt bolts with a 14mm and 19mm
wrench.
50
SET-UP INSTRUCTIONS
INTERCEPTOR GTR 250
To Next Page
Loading...
